LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> Engine Mechanical >> Exhaust >> Catalytic Converter, Intake And Exhaust System - Removal, Replacement And Installation >> Turbocharger (B5204T5; 2005-2007) >> Turbocharger (TC), replacing >> Installation >> Installing the bevel gear

Installing the bevel gear

Fig 1: Identifying Bevel Gear And Screws
GLL109692Courtesy of VOLVO CARS OF NORTH AMERICA.

For AWD vehicles carry out the following work: 

Before installing the bevel gear, lubricate the spline joint between the transmission and the bevel gear. Use grease. See: Splines greasing .

Ensure that the mating surfaces on the transmission and bevel gear are clean. Install the bevel gear. Lightly tighten the M10 screws alternately. Tighten.

scientia non olet · About LEMON Manuals