Installing the throttle body (electronic throttle module (ETM))

Fig 1: Identifying Throttle Body, Screws And Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install 

• starter motor, tighten with 40 Nm  against the transmission and 30 Nm  for the bracket against the engine block
• the connector for the new throttle body (TB) with the cable on the outside of the starter motor bracket.

Secure the cable so that there is no risk of damage or a broken connection.

Fig 2: Identifying Intake Manifold Between Air Cleaner And Throttle Body

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install 

• new throttle body  with new gasket  . Tighten with 10 Nm 
• the intake manifold between the air cleaner (ACL) and the throttle body (TB) and the connected hoses
• the intake pipe between the front cover plate and the air cleaner (ACL)
• the cable to the battery negative terminal.