LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> Engine Mechanical >> Exhaust >> Catalytic Converter, Intake And Exhaust System - Removal, Replacement And Installation >> Intake And Exhaust Manifolds (B5234T3; B5244T3; 2001) >> Throttle body (electronic throttle module (ETM)), replacing >> Removing >> Remove the cylinder block screws

Remove the cylinder block screws

Fig 1: Identifying Cylinder Block Screws
GLL154202Courtesy of VOLVO CARS OF NORTH AMERICA.
CAUTION:

The wiring to the throttle body must not be cut off. The throttle body may need to returned complete.

If the wiring to the throttle body is behind the bracket for the starter motor:

Slacken off the nuts (x 2).

Remove the screw.

Remove any tie straps and disconnect the connector for the throttle body.

Route the wiring for the throttle body from the reverse of the bracket for the starter motor.

scientia non olet · About LEMON Manuals