LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> Engine Mechanical >> Exhaust >> Catalytic Converter, Intake And Exhaust System - Removal, Replacement And Installation >> Intake And Exhaust Manifolds (B5234T3; B5244T3; 2001) >> Throttle body (electronic throttle module (ETM)), replacing >> Installing >> Install the cylinder block screws

Install the cylinder block screws

Fig 1: Identifying Cylinder Block Screws
GLL154202Courtesy of VOLVO CARS OF NORTH AMERICA.

Position the wiring for the throttle body behind the bracket for the starter motor.

Install the screws in the cylinder block.

Tighten the 2 x nuts and the screws.

Connect the connector and install the tie strap.

NOTE:

If the wiring was not behind the bracket for the starter motor, it must be secured along the cable duct by two tie straps.

scientia non olet · About LEMON Manuals