Battery, Replacing
NOTE:
As the illustrations in this service information are used for different model years and / or models, some variation may occur. However, the essential information in the illustrations is always correct.
NOTE:
Check the performance of the battery to determine whether it is defective or not. See Fault-Tracing And Testing The Battery .
Preparatory work
Ignition off.
WARNING:
See Battery, Disconnecting .
Fold up the floor hatch.
Unhook the strap.
Push the floor hatch and compartment to one side.
Removal
Remove:
- the nut securing the mounting bracket to the floor
- the screws holding the mounting bracket against the rear crossmember
- the mounting bracket
- the protective cover
- the drain hose (1) from the side of the battery
- the battery negative lead
- the battery positive lead.
Detach the battery mounting.
Remove the battery.
NOTE:
For tightening torques, see Tightening Torque .
WARNING:
See Battery, Disconnecting .
Installation
Install:
- the battery
- the battery mounting. Screw into place
- the battery positive lead. Screw into place
- the battery negative lead. Screw into place
- the drain hose on the side of the battery
- the protective cover
- the mounting bracket
- the screws holding the mounting bracket against the rear crossmember
- the nut securing the mounting bracket to the floor
- the floor compartment and hatch. Hook the strap into place. Close the hatch.