Removing the drive shaft

Fig 1: Removing Drive Shaft Screw Using A Screwdriver As A Counter Hold On Brake Disc

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove: 

• the drive shaft screw. Use a screwdriver as a counterhold on the brake disc
• the locating pin holding the brake disc
• the brake disc.

Slacken off the end of the drive shaft in the hub by knocking the drive shaft into the hub approximately 10-15 mm  .

Use a rubber or copper mallet.

Fig 1: Identifying Hub With New Screws Installation

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Remove the drive shaft. Knock the drive shaft out using a brass drift. Hang the drive shaft as shown in the illustration
• Secure the spring strut in position
• Remove the 4 screws for the hub.