Removing The Clamp From The Inner Boot (If The Boot Is Being Replaced)

Fig 1: Clamp From Inner Gaiter

GLL109786

Courtesy of VOLVO CARS OF NORTH AMERICA.

Cut the boot and remove it from the shaft.

NOTE:

The outer constant velocity joint can be cleaned while assembled. For checking and cleaning see Cleaning / Checking The Outer Constant Velocity Joint .

NOTE:

The inner constant velocity joint can be cleaned while assembled and blown clean prior to greasing.

To disassemble the joint, see Clean And Mark Up The Constant Velocity Joint , Separate The Shaft And Pull Out The Inner Joint and Checking and inspection .

To assemble and lubricate the outer joint:

See Installing The Inner Ring In The Ball Holder , Lubricating The Constant Velocity Joint , Replacing The Circlip , Installing New Boots On The Drive Shaft , Greasing The Boot And Venting The Boot .