LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Axle, Drive Shafts - Removal, Replacement And Installation >> Drive Shaft, CV Joint (B5254T4, TF-80SC AWD; 2006-2007) >> Drive Shaft Right, Replacing >> Removal >> Removing The Drive Shaft From The Gearbox

Removing The Drive Shaft From The Gearbox

Fig 1: Identifying Bearing Cap Screws
GLL109802Courtesy of VOLVO CARS OF NORTH AMERICA.

Position a container under the gearbox to collect the oil (Applies to cars with manual and automatic AW50-42 transmissions).

Remove the bearing cap from the support bearing for the drive shaft.

Pull the drive shaft out of the gearbox.

NOTE:

Pull the inner section of the drive shaft closest to the gearbox when removing it. There is no axle stop in the inner joint.

NOTE:

Take care not to damage the drive shaft when removing it from the gearbox.

Install: 9995488 to the transmission (Applies to vehicles with manual and automatic transmission AW50-42).