LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Axle, Drive Shafts - Removal, Replacement And Installation >> Drive Shaft, CV Joint (B5244T5, M66; 2005-2008) >> Drive Shaft Left, Replacing >> Oil Level, Checking >> Introduction

Oil Level, Checking: Introduction

Conditions 

Fig 1: Identifying Oil Level Graph
GLL102142Courtesy of VOLVO CARS OF NORTH AMERICA.

The difference between the MAX and MIN volumes is 0.5 liters. Check the oil temperature in the transmission.

At room temperature (+20 °C) the oil level is close to the MIN mark on the "cold area".

At room temperature (+20 °C) and low oil level  the oil barely reaches the dipstick.

The "cold range" (+40 °C) is reached after approximately 15 minutes idling in the workshop, while the "hot range" (+80 °C) is reached after approximately 30 minutes highway driving at an air temperature above +15 °C.

NOTE:

Carry out the check at an oil temperature of +80 °C. Go to car communication function group 4. Select the digital display parameter. Select the parameter for the transmission oil temperature.

Preparing to check the oil level 

Park the car on a level surface.

Apply the parking brake.

Apply the foot brake.

Let the engine idle.

Move the gear selector lever to position P.

Move the gear selector through all positions. Wait in each position for approximately 3 seconds 

Move gear selector to position P and wait approximately 2 minutes before checking the oil level.

The dipstick must be pushed down as far as possible  into the dipstick tube.

CAUTION:

Wipe the dipstick with a nylon cloth or similar. Do not use a cloth which may leave fluff or threads.