LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Axle, Drive Shafts - Removal, Replacement And Installation >> Drive Shaft, CV Joint (B5204T5, Aw55-50/51SN; 2004-2007) >> Drive shaft left, replacing >> Preparations >> Taking measurements

Taking measurements

Fig 1: Measuring Over Wheel Spindle And Spring Strut At Upper Screw
GLL109809

Measure over the wheel spindle and spring strut at the upper screw as illustrated.

Clean off any dirt and contamination from the measuring surfaces.

Note the measurement. The measurements are made so that the same camber angle can be obtained when installing.

scientia non olet · About LEMON Manuals