Installing The Final Drive Housing

Fig 1: Positioning Mobile Jack (998 5972) Together With Fixture (999 5972)

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE:

Check that the bleed hose on top of the final drive is not kinked. Check that the bleed hose is connected. Check that the bleed hose is secured to the sub-frame using a tie strap.

Lift the cover up to the final drive housing and rear axle member.

Install the 8 screws and the screw for the front bushing in the final drive.

Lightly tighten the screws alternately.

Then tighten the screws for the cover. Tighten to 100 Nm .

Tighten the screw for the front bushing for the final drive. Tighten to 80 Nm .