Installing the Active on Demand Coupling

Fig 1: Locating Active On Demand Coupling, Final Drive Screws & Bolts

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the coupling on the final drive housing.

Tighten the screws crosswise to light contact. Then tighten to 25 Nm crosswise.

Connect the connector to the wiring.

Fig 2: Identifying Mobile Jack & Jimmy Bar

Courtesy of VOLVO CARS OF NORTH AMERICA.

Press the final drive up against the sub-frame.

Install the screw. Use a jimmy bar to move the anti-roll bar to one side. Tighten to 80 Nm .

CAUTION:

Protect the surface of the anti-roll bar from damage.

Remove the mobile jack.