Removing Components From The Active On Demand Coupling
Remove the throttle valve and the temperature/pressure sensor from the coupling.
A = Throttle valve.
B = Temperature/pressure sensor.
Use a large pair of pliers for removal. Grip the end of the throttle valve. Hold the pliers stable and pull the valve straight out.
NOTE:
Make sure that no damage is caused when removing the throttle valve. The valve cannot be replaced separately. The throttle valve is removed in order to be installed in the control module. This is done to minimize the risk of damage occurring to the contacts when installing.
Remove:
- the temperature/pressure sensor as above
- the O-ring from the throttle valve seat in the coupling housing.