LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake Bleeding And Disc - General Specifications >> Removal & Installation >> Rear Disc Brake Pads >> Installation

Rear Disc Brake Pads: Installation

  1. Press piston back into cylinder on brake caliper. Check that the dust cover is correctly positioned.
  2. Install new brake pads. See Figure.
  3. Install the brake caliper. See Figure.
  4. Instal the rubber sleeves of the locating pins. Replace if necessary.
  5. Lubricate the locating pins with grease. Insert the locating pins (2) into the rubber sleeves. See Figure. The pins should slide into the sleeves easily.
  6. Tighten locating pins to specification. See TORQUE SPECIFICATIONS .
  7. Install protective caps (1). See Figure.
  8. Install retaining spring (3). See Figure.
  9. Depress brake pedal a few times. Top off brake fluid if necessary. Adjust parking brake as required. See PARKING/EMERGENCY BRAKE  under ADJUSTMENTS.
  10. Install wheels and tighten to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals