LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake Bleeding And Disc - General Specifications >> Removal & Installation >> Parking Brake Shoes >> Installation

Parking Brake Shoes: Installation

  1. Install the brake shoes.
  2. Install the spacer and the small return spring on the brake shoes. See Fig 1.
    Fig 1: Installing Spacer For Parking Brake Shoes
    G00220602Courtesy of VOLVO CARS OF NORTH AMERICA.
  3. Install the lower mounting spring. Press in the spring (1) and turn it slightly (less than 1/4 turn). See Figure.
  4. Install the upper mounting spring. Check that the brake shoes are in the correct position in the expander.
  5. Install the return spring be the expander. Check that the mounting springs are secure.
  6. Install the brake disc and the locating pin. Tighten the pin to specification. See TORQUE SPECIFICATIONS .
  7. Check the brake pads and replace if necessary.
  8. Press the brake pads in the caliper apart. Install the caliper holder and the brake caliper. See Fig 2.
    Fig 2: Installing Rear Caliper
    G00220603Courtesy of VOLVO CARS OF NORTH AMERICA.
    9. NOTE: Manufacturer recommends using new brake caliper holder bolts if loosened or removed.
  9. Tighten the NEW caliper holder mounting bolts to specification. See TORQUE SPECIFICATIONS .
  10. Install wheels and tighten to specification. See TORQUE SPECIFICATIONS .
  11. Adjust parking brake. See PARKING/EMERGENCY BRAKE  under ADJUSTMENTS.
scientia non olet · About LEMON Manuals