LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake Bleeding And Disc - General Specifications >> Inspection >> Measuring Lateral Run-Out >> Front Wheel Hub

Front Wheel Hub

  1. Raise and support vehicle. Remove wheel to be measured.
  2. Remove mounting screws for brake caliper holder. Hang caliper from spring using a wire.
  3. Remove brake disc.
  4. Install bracket included in Measurement Tool Set (999 5418). See Fig 1.
  5. Install dial indicator in the bracket. See Fig 1.
  6. Place dial indicator point against hub flange. See Fig 2.
  7. Rotate hub and note dial indicator run-out. If lateral run-out exceeds specifications, replace hub. See DISC BRAKE SPECIFICATIONS .
  8. To install, reverse removal procedure. Tighten brake disc locating pin and brake caliper holder to specifications. See TORQUE SPECIFICATIONS .
Fig 1: Installing Dial Indicator For Front Hub
G00216287Courtesy of VOLVO CARS OF NORTH AMERICA.
Fig 2: Measuring Lateral Run-Out Of Front Hub
G00216288Courtesy of VOLVO CARS OF NORTH AMERICA.
scientia non olet · About LEMON Manuals