Checking components and wiring
If the car is equipped with a 10-pin connector
Check the cable between door control module terminal #10B and power door mirror terminal #4 for an open-circuit according to Open-circuit, permanent faults , check for a short-circuit to supply voltage according to Short-circuit to supply voltage, permanent faults .
Check the cable between door control module terminal #8B and power door mirror terminal #6 for an open-circuit according to Open-circuit, permanent faults .
If the car is equipped with a 16-pin connector
Check the cable between door control module terminal #10B and power door mirror terminal #6 for an open-circuit according to Open-circuit, permanent faults , check for a short-circuit to supply voltage according to Short-circuit to supply voltage, permanent faults .
Check the cable between door control module terminal #8B and power door mirror terminal #13 for an open-circuit according to Open-circuit, permanent faults .
Remedy as necessary.
Other information:
- For further information about signals and other values, see Signal specification .
- To connect the breakout box, see Connecting the breakout box .
- To access the connector for the power door mirror:
- For -2006 see Outside temperature sensor door mirror, replacing (-2006)
- For 2007- see Outside temperature sensor (2007-)
- To replace the bulb in the power door mirror, see Bulb, ground lighting, door mirror, replacing .