Checking the components and wiring
Check the cable between door control module terminal #10B and power door mirror terminal #6. Check for an open-circuit. Check for a short-circuit to supply voltage.
Check the cable between door control module terminal #8B and power door mirror terminal #13 for an open-circuit.
Remedy as necessary.
Other information:
- See Signal specification
- See Connecting the breakout box
- To access the power door mirror connector:
- For -2006 see Outside temperature sensor door mirror, replacing (-2006)
- For 2007- see Outside temperature sensor (2007-)
- See Bulb, door mirror, ground lighting
- See Checking wiring and terminals
- Continue
Refer to Verification
Check the cable between door control module terminal #10B and power door mirror terminal #6. Check for an open-circuit. Check for a short-circuit to supply voltage.
Check the cable between door control module terminal #8B and power door mirror terminal #13 for an open-circuit.
Remedy as necessary.
Other information:
- See Signal specification
- See Connecting the breakout box
- To access the power door mirror connector:
- For -2006 see Outside temperature sensor door mirror, replacing (-2006)
- For 2007- see Outside temperature sensor (2007-)
- See Bulb ground lighting door mirror, replacing
- See Checking wiring and terminals
- Continue
Refer to Verification