Installing the Rear Bumper

Fig 1: Aligning Lugs On Bumper In Channels On Slide Mounting

Courtesy of VOLVO CARS OF NORTH AMERICA.

Guide the hooks (6) for the bumper into the grooves (7) on the side bracket. Press firmly at the top so that the hooks engage.

HINT: This operation is easier with two people. 

Install: 

• the screws, 1 on each side, at the bottom of the casing
• the 4 clips on the underside of the casing
• the 4 M8 nuts. Tighten.

HINT: Use butyl tape to secure the nuts in the sleeve. Otherwise the nuts are easy to lose. 

Fig 2: Installing Screw On Each Side

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install: 

• the screw (x1). Tighten
• the connector for the antenna amplifier. Alternatively the screw for the bracket
• the soundproofing
• the sub-woofer if applicable
• the cover and the soundproofing on the right-hand side.
• the battery. See Battery, Replacing
• the floor hatch.