Installing the Rear Bumper

Fig 1: Aligning Lugs On Bumper In Channels On Slide Mounting

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

In reverse order.

NOTE: Align the lugs (6) on the bumper in the channels (7) on the slide mounting. Press at the top so that the lugs secure.

HINT: Two people are required for this task.

Fig 2: Drilling Out One Rivet From Each Side Where Edge Of Fender Meets Bumper Bracket

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE: Replace the rivets (4) with spring nuts and screws.

Fig 3: Identifying Spring Nut

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install 1 spring nut on each side.

Fig 4: Installing Screw On Each Side

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install 1 screw on each side. Tighten.