Intermittent fault
Check the control module and power door mirror connectors. Check for contact resistance, oxidation and loose connections.
If the car is equipped with a 16-pin connector
Check the cable between driver door module (DDM) terminal #14A and power door mirror terminal #2. Check the cable between control module terminal #18A and power door mirror terminal #3. Check these cables for an intermittent short-circuit to supply voltage. Check for an intermittent open-circuit.
Try a new outside temperature sensor if no fault was found.
Other information:
- See Connecting the breakout box
- See Signal specification
- See Replacing the mirror
- See Outside temperature sensor door mirror, replacing
- See Checking wiring and terminals .
- Continue
Refer to Information