Intermittent fault
Check the control module and power door mirror connectors. Check for contact resistance, oxidation and loose connections.
If the car is equipped with a 10-pin connector
Check the cable between control module terminal #14A and power door mirror terminal #1. Check the cable between control module terminal #18A and power door mirror terminal #3. Check these cables for an intermittent short-circuit to supply voltage. Also check for an intermittent open-circuit.
If the car is equipped with a 16-pin connector
Check the cable between control module terminal #14A and power door mirror terminal #2. Check the cable between control module terminal #18A and power door mirror terminal #3. Check these cables for an intermittent short-circuit to supply voltage. Also check for an intermittent open-circuit.
Try a new outside temperature sensor if no fault was found.
Other information:
- To connect the breakout box, see Connecting the breakout box
- For further information about signals and other values, see Signal specification
- To access the connector for the power door mirror, see Replacing the mirror
- To access and replace the outside temperature sensor, see Outside temperature sensor door mirror, replacing
- See Checking wiring and terminals .
- Continue
Refer to Information