Replacing the component

Fig 1: Identifying Ignition OFF

GLL101045

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ignition off.
The driver door module (DDM) has registered an internal fault.

NOTE:
A new control module is delivered without software. The control module must be programmed in order to function after replacement.

After replacing the control module the window position must be initialized.
- Ignition on.
Move the window to its upper limit position using manual control.

Initialize the window.

During initialization, the window will automatically go down to its lowest position and then go back up again.

Other information:
- For further information about programming and replacing the control module, see Lock mechanism front side door, replacing .
Fig 2: Identifying VCT2000 Diagnostic Tool Symbol In VIDA
Courtesy of VOLVO CARS OF NORTH AMERICA.