Replacing the component

Fig 1: Identifying Ignition OFF

GLL101045

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ignition off.
The control module has registered an internal fault.

NOTE:
A new control module is delivered without software. The control module must be programmed when it has been replaced.

Other information:
- For further information about programming and replacing the control module, see Lock mechanism front side door, replacing .
After replacing the control module the window position must be initialized.

Ignition on.

Move the window to its upper limit position using manual control.

Initialize the window.

During initialization, the window will automatically go down to its lowest position and then go back up again.

Fig 2: Identifying VCT2000 Diagnostic Tool Symbol In VIDA
Courtesy of VOLVO CARS OF NORTH AMERICA.