Intermittent fault
Check the connectors for the control module and power window lift motor. Check for contact resistance and oxidation. Check for loose connections.
Check the cable between control module connector terminal #B4 and power window lift motor connector terminal #3. Check for an intermittent open-circuit.
Check the cable between the control module connector terminal #3B and the power window lift motor connector terminal #6. Check for an intermittent open-circuit.
Other information:
- To connect the breakout box, see Connecting the breakout box
- For further information about signals and other values, see Signal specification
- To access the control module, see Driver's door module / passenger door module (DDM/PDM), replacing
- To access and replace the power window mechanism, see Window lift mechanism front side door, replacing
- For information about checking the power supply and ground terminal, see Checking the power supply and ground terminals
- See Checking wiring and terminals .
- Continue
Refer to Information