Checking Components And Wiring
HINT: Check that the TV system for the relevant country and a suitable station is set (EU only).
- Ignition off
- Remove the connector from the road traffic information (RTI) control module and TV receiver
Check the cable terminals on the connector. The cable terminals must not be damaged or pressed back.
Check both the cables and connectors O and P between the (RTI) road traffic information control module and the TV receiver. Check for a short-circuit to supply voltage. Check for a short-circuit to ground. Check for an open-circuit.
Remedy as necessary.
Other information:
- To access or replace the TV receiver, see Replacing the TV Receiver
- For information about programming and replacing the road traffic information (RTI) control module, see Road Traffic Information Module (RTI), Replacing
- To fault-trace the wiring and terminals, see Checking Wiring And Terminals .
Was a fault detected?
- YES
Refer to Replacing the component
- NO
FAULT NOT FOUND: Troubleshooting has been completed.