Checking the Component
- Check that the fuses for the RTI (road traffic information) and audio control module are intact. The fuses are located in the passenger compartment and the cargo area fuse boxes
- Ignition on.
Measure the voltage between #J11 and #J15. Voltage must be approximately 12 V.
Measure the voltage between #J12 and #J15. Voltage must be approximately 12 V.
Measure the voltage between #J13 and #J15. Voltage must be approximately 12 V.
Check the cable between the display screen terminal #J18 and control module terminal #C12. Check for a short-circuit to supply voltage. Check for a short-circuit to ground. Check for an open-circuit.
Remedy as necessary.
Other information:
- To access and replace the fuses, see Fusebox, Passenger Compartment, Replacing
- To access and replace the display screen, see Display Screen/Loudspeaker, RTI (Road Traffic Information), Replacing
- To program and access or replace the RTI (road traffic information) control module, see Removal
- To connect the breakout box, see CONNECTING THE BREAKOUT BOX TO THE ROAD TRAFFIC INFORMATION (RTI) CONTROL MODULE
- For information about signals and connectors, see RTI Control Module (To Display) and Display (To RTI Control Module And "Chassis")
- See Checking Wiring And Terminals
Was a fault detected?
- YES
OKAY: Troubleshooting has been completed.
- NO
Refer to Replacing the Component