Installing the handset

Fig 1: Prying Out Panel Using Weatherstrip Tool

Courtesy of VOLVO CARS OF NORTH AMERICA.

Open the center console locker
Press the panel down at the front edge of the center console locker. Carefully pry out the panel using a weatherstrip tool until the two catches release
Remove the panel.

Fig 2: Prying Off Bottom Of Center Console Locker At Front Edge Using Weatherstrip Tool

Courtesy of VOLVO CARS OF NORTH AMERICA.

Pry off the bottom of the center console locker at the front edge using the weatherstrip tool
Detach the floor. Place the floor to one side.

Fig 3: Identifying Center Console Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 4: Pressing Catches Using Small Screwdriver

Courtesy of VOLVO CARS OF NORTH AMERICA.

Insert a small screwdriver between the center console locker hinges and the center console
Press in the two catches on the inside. At the same time pull the rear end backwards until it releases
Position the rear end at the rear edge of the center console. Do not disconnect the connectors.

Fig 5: Cutting Out Rear End Of Center Console Locker To Make Room For Carphone Handset Cable And Rubber Seal

Courtesy of VOLVO CARS OF NORTH AMERICA.

Cut out the rear end of the center console locker to make room for the carphone handset cable and rubber seal.

Fig 6: Identifying Screws For Center Console Locker Cover

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the two screws. Remove the panel from the inside of the center console locker cover. Place the cover to one side. It will not be reused
Hook the front edge of the new handset holder on the inside of the center console locker cover
Tighten the handset using the two screws.

Fig 7: Identifying Cables And Rubber Bushing

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the new carphone handset in the holder
Insert the carphone cable and the rubber bushing (1) in the bottom of the center console locker. Install the rubber seal in the hole in the rear end of the center console locker so that the cable is pointing upwards
Connect the carphone cable (2) with the previously pre routed cable (3) from the center console
Insert the rubber bushing into the hole as far as possible.

Fig 8: Identifying Carphone Handset Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

Press the connector (1) for the carphone handset into the existing clamp on the inside of the rear end of the center console
Reinstall the rear end of the center console. Press the rear end by the top edge. Ensure that the no cables are trapped
Secure the front and rear edges of the center console using the four screws.

Reinstall: