Adjustment, Japan

WARNING:

Always adjust the headlamp beam according to the legal requirements of the market.

Fig 1: Identifying Lighting Control Buttons

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ignition and low beam on
Check the button that controls the lighting level. Set the button to the 0 position
Check the current. Check that the power supply is sufficient for the desired beam level
CAUTION:
Always adjust the beam with low beam switched on.

Fig 2: Adjusting Beam Vertically And Horizontally (1 Of 2)

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Adjusting Beam Vertically And Horizontally (2 Of 2)

Courtesy of VOLVO CARS OF NORTH AMERICA.

Adjust the beam vertically (Y) using an Allen screw, as shown in the illustration
Adjust the beam horizontally (X) using an Allen screw, as shown in the illustration
HINT: Use a Ø6 mm Allen screw.

WARNING:

Always adjust the headlamp beam according to the legal requirements of the market.