Headlamp/Bulb, Replacing: Installation: Headlamps
- Position the headlamp
- Position the washer hose through the hole on the bracket for the wiper motor
- Pull out the top edge of the casing. Position the headlamp
- Thread in the upper screws
- Check the position of the air bleed hoses
- Pull the casing down from the guide
- Thread in the outer and inner screws
- Press in the headlamp. Tighten the upper screws
- Tighten the outer and inner screws
- Install the holder and guide for the cover
- Everything else is installed in reverse order
- Check and adjust the headlamp beam. See Headlamps, Aligning .