Connecting the DVD reader

Fig 1: Identifying Cables

Courtesy of VOLVO CARS OF NORTH AMERICA.

Connect: 

• the cable (1) for the display screen
• the power supply cable (2)
• the cable (3) for the Global Positioning System (GPS) aerial
• the cable (4) to the aerial amplifier
• the DIN cable (5) for the radio.
  NOTE:

  If the TV is to be installed carry out the operation now. Use installation Instructions 8637033.

Fig 2: Identifying DVD Drive, Console, And Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Install the bracket with the DVD reader in the rear edge of the rear wheel well using three screws (1) from the kit. Tighten the screws. Tighten to 10 Nm (7 lbf.ft.) 
• Clamp the blue excess connector and other wiring at the DVD reader using two tie straps.