Installation and final tasks (applies only to the S60)
Courtesy of VOLVO CARS OF NORTH AMERICA.
- Position the loudspeaker and the mountings (1) in the panel around the rectangular hole in the parcel shelf.
- Adjust the loudspeaker towards the two pre-drilled holes in the panel.
- Install the screws (2) from the kit. Tighten the loudspeaker.
- Connect the loudspeaker to the pre-routed connector.
- Carry out the above procedure on the opposite side.
- Thread the seat belts through the holes in the parcel shelf.
- Reinstall the parcel shelf panel.
- Tighten the seat belt end mountings using the new screws from the kit. Tighten to 50 Nm (37 lbf ft.)
.
- Reinstall the C-post panels
- Reinstall the side bolsters.
- Reinstall the seat cushion, if removed.
- Reinstall the seat belts in the guides on the right and left hand side cushions.
- Fold the backrests back into position.