Bluetooth, mute kit: Preparations

• Turn the ignition switch to position 0.
• Disconnect the battery negative lead.
  NOTE:

  Wait at least five minutes before disassembling the connectors or removing other electrical equipment.

• Turn the clip (1) a quarter turn anti-clockwise.
• Pull the panel out by the rear edge.
• Then pull the panel backwards until the hooks release.
• Remove the panel.

• Remove the screws and sound proofing bracket.

• Remove the sill trim panel (1).

Applies to the S60 and V70 

• Open the glovebox.
• Lift the two hooks on each side past the lugs.

Applies to the S60 and V70 

• Unhook the damping.

Applies to the S60 and V70 

1. Remove: 
   • the eight screws.
   • the connector for the glove box lighting.
   • the connector for floor lighting.
   • the glove box.