Cargo compartment, preparations
- Remove the seat cushion (1) by pulling it up at the front edge, pulling it forward and then lifting it away.
- Fold the right-hand rear backrest forward.
- Remove the sill trim panel at the right-hand rear door.
Applies to right-hand drive cars
- Remove the sill panel on both sides.
- Remove the cargo compartment carpet.
- Press the center of the clip at the bottom of the folding side panel. Press the clip until a click is heard.
- Remove the clips.
- Turn the handle (1) on the right-hand side through 90 degrees.
- Remove the clips.
- Fold the side panel inwards and lift it out.
Remove:
- the clip (1)
- the clips (2)
- the panel.
Fig 7: Folding Back Rear Seats Backrest And Pulling Cable Inside Floor Carpets And Lower B Post Panel To Right-Hand Side
Applies to right-hand drive cars
- Fold back the rear seat's backrest temporarily.
- Pull the cable inside the floor carpets and the lower B post panel, over to the right-hand side.
- Route the cable inside the floor carpets and the lower B post panel on towards the rear edge of the right-hand rear wheel arch. Route the cables along the existing cables harnesses to the cargo compartmentNOTE:
Ensure that the cable is positioned so that there is no risk of it catching or rubbing.