Connecting to the DVD unit
- Position the single cables in the routed cable harness backwards along the cable. Insulate and secure them by the cable with foam tape from the kit. The two green connectors must be loose.
- Unscrew the screws (1) and remove the DVD drive with the console from the side of the body.
- Unplug the power supply connector (1) to the DVD unit.
- Plug in the connector (1) previously detached from the DVD unit to one connector (2) in the cable harness to the Jukebox power supply.
- Plug in the other connector (3) for the Jukebox power supply to the DVD unit.
- Connect the DIN cable (4) from the Jukebox. (For cars with TV or Sirius unit, the DIN cable must be connected to this instead.
- Reinstall the DVD drive and tighten the screws to 10 Nm (7.5 lbf.ft.) .
Applies to cars -2004
- Replace the fuse in fuse holder 10 in the rear electronic module (REM) with a 10 A fuse.
- Clamp the cables in at the cable harness/cable duct with a tie strap from the kit.
- Clamp any cable excess.
- Reinstall the parcel shelf panel.
- Reinstall the C-post panels.
- Reinstall the front and the folding rear panel in the left-hand side of the cargo compartment.
- Reinstall the side bolster.
- Fold the backrests back into place.
- Reinstall the seat cushion.
- Turn the ignition key to position II.
- Reconnect the battery negative lead.
- Reinstall the cargo compartment carpet.
Check that the system is working.
- Install the memory unit (DMS) in the Jukebox.
- Switch on the radio and select the 10-CD changer.NOTE:
The first time the system is started it takes approx. 30 seconds before it is operational.
- Check that the parts shown in the illustration are in the storage compartment supplied with the Jukebox, and that this is positioned as shown in the illustration:
- USB docking station
- Voltage adapter
- CD-ROM Jukebox
- Owner's Manual