Replacing the component
- Replace the SRS control module according to SRS control module .
- Continue
Refer to Verification
Check the wiring and repair or replace the SRS cable harness.
- Continue
Refer to Verification
There is an open-circuit in the cable between central locking system connector #A10 and SRS control module connector #40 if the ohmmeter displays an infinite value.
- Check the cable and repair or replace the SRS cable harness.
- Continue
Refer to Verification
- Replace the central locking system control module according to Checking the 10-CD changer .
- Continue
Refer to Verification
No short-circuit to ground in the cable between SRS control module connector #40 and central locking control module connector #10A.
- Replace the SRS control module according to SRS control module .
- Continue
Refer to Verification
There is a short-circuit to ground in the cable between the SRS control module connector and the central locking control module if the ohmmeter reads approximately 0 Ω.
- Check the cable and repair or replace the SRS cable harness.
- Continue
Refer to Verification