Checking the central locking switch: Verification

HINT: After carrying out the repair check that the fault has been remedied as follows: 

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Connecting Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off.
• Reconnect the connectors, reinstall components etc.
• Ignition on.

  Read off central locking switch status.

  Press the central locking switch, first to its locking position and then to its unlocking position.

  The values should change from HIGH to LOW when the central locking switch is pushed to the relevant position.

  NOTE: A diagnostic trouble code (DTC) is stored if the central locking switch is held in the locking/unlocking position for more than 10 seconds.
  Fig 3: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Are these readings OK. 

• OK 

  OKAY:  Troubleshooting has been completed.

• NOT OK 

  Refer to Information