Checking component
Try listening to another CD in the 10-CD changer.
Is there sound reproduction from the 10-CD changer?
- YES
OKAY: Troubleshooting has been completed.
- NO
Check that fuse 10 in the cargo compartment integrated relay/fusebox is intact.
Ignition on.
Measure voltage between #G1 and #G2 on the 10-CD changer connector. Voltage should be approximately 12 V.
Measure voltage between #E3 and #G1 on the 10-CD changer connector. Voltage should be approximately 12 V.
Check the cable between the audio unit #E1 and the 10-CD changer #E1 for a short-circuit to supply voltage according to Short-circuit to supply voltage. Permanent faults and for a short-circuit to ground according to Short-circuit to ground, permanent faults and for open-circuits according to Open-circuit, permanent faults .
Check the cable between the audio unit #E4 and the 10-CD changer #E4 for a short-circuit to supply voltage according to Short-circuit to supply voltage. Permanent faults and for a short-circuit to ground according to Short-circuit to ground, permanent faults and for open-circuits according to Open-circuit, permanent faults .
Check the cable between the audio unit #E5 and the 10-CD changer #E5 for a short-circuit to supply voltage according to Short-circuit to supply voltage. Permanent faults and for a short-circuit to ground according to Short-circuit to ground, permanent faults and for open-circuits according to Open-circuit, permanent faults .
Check the cable between the audio unit #E6 and the 10-CD changer #E6 for a short-circuit to supply voltage according to Short-circuit to supply voltage. Permanent faults and for a short-circuit to ground according to Short-circuit to ground, permanent faults and for open-circuits according to Open-circuit, permanent faults .
Check the cable between the audio unit #E7 and the 10-CD changer #E7 for a short-circuit to supply voltage according to Short-circuit to supply voltage. Permanent faults and for a short-circuit to ground according to Short-circuit to ground, permanent faults and for open-circuits according to Open-circuit, permanent faults .
Check the cable between the audio unit #E8 and the 10-CD changer #E8 for a short-circuit to supply voltage according to Short-circuit to supply voltage. Permanent faults and for a short-circuit to ground according to Short-circuit to ground, permanent faults and for open-circuits according to Open-circuit, permanent faults .
Other information:
- For information about programming and accessing/replacing the head unit/audio control module, see Radio Cassette Player, Replacing .
- To access/replace the 10-CD changer, see Windshield antenna / amplifier, CD player, replacing .
- To connect the breakout box, see Connecting the Breakout Box, Audio Control Module .
- For information about signals and connectors, see Signal Specification, Audio Control Module .
Was a fault detected?
- YES
OKAY: Troubleshooting has been completed.
- NO