Parking Brake - Removal & Installation (XC)

• Brakes
  • Handbrake, brake shoes, replacing
    • Notes
    • Removal
      • Remove the panel covering the handbrake lever
      • Release the handbrake adjuster
      • Remove the brake caliper and holder
      • Remove the brake disc
      • Remove the brake shoes
      • Cleaning and checking
    • Installation
      • Install the brake components
      • Installation brake components, continued
      • Install the brake disc and the locating pin
      • Install the brake caliper and the caliper holder
      • Adjust the handbrake
      • Install the panel over the handbrake lever
  • Replacing brake cables
    • Removal
      • Remove the center console
    • Remove the mechanical cable from its segment
    • Secure a heavy wire to the end of the mechanical cable
    • Remove the mechanical cable
    • Remove the brake caliper with the holder and the brake disc
    • Remove the expander
    • Remove the guide sleeve for the cable sleeve
    • Remove the mechanical brake cable
    • Installation
      • Install the cable in the wheel unit
      • Install the expander on the mechanical cable
      • Install the brake cable in its clamps
      • Pull the cable up to the brake lever
      • Install the rubber seal against the bodywork
      • Install the cable to the parking brake segment
      • Install the center console
      • Install the brake disc and the brake caliper with the holder
  • Replacing parking brake lever
    • Removing the center console
      • Remove the side panels
      • Remove the gear selector lever boot and the connector
      • Separate the panel and top panel
      • Remove the panel (1) over the parking brake lever
      • Pull up front edge of the bracket
      • Preparations for removing the center console
      • Remove the center console
    • Replacing the parking brake lever
      • Remove the parking brake lever
      • Install the parking brake lever
    • Installing the center console
      • Install the center console
      • Install the panel for the parking brake lever
      • Install the panel and connector
      • Reinstall the side panels