Transferring components

Fig 1: Identifying Embossed Cover Cut-Out Pattern

Courtesy of VOLVO CARS OF NORTH AMERICA.

Cars with fog lamps: 

Cut out the embossed cover (1). Cut around the outer marking (2).

Cut a groove around the marking partway through the thickness. This is done to make a marking to follow when cutting.

Carefully cut through the rest of the cover.

Remove the cut out cover and trim the edges if necessary.

HINT: Use a hot knife. 

Transfer the fog lamps. See Fog lamps, front, replacing .

Fig 2: Identifying Center Trim Strip And License Plate Holder

Courtesy of VOLVO CARS OF NORTH AMERICA.

Transfer: 

• the radiator grille. See Radiator grille, replacing (2004-)
• the center trim strip
• the license plate holder and the license plate.