Removing front bumper

Fig 1: Identifying Front Bumper Casing

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the left and the right trim strip.

Fig 2: Identifying Front Bumper, Casing, Wiper Arms And Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove: 

• the 2 screws. Use a 13 mm long socket
• the 6 clips, on the upper side of the casing
• the 2 clips on the underneath of the bumper (5).

Fig 3: Identifying Screw Pressed Backwards To Release Bumper Bracket

Courtesy of VOLVO CARS OF NORTH AMERICA.

Slacken off the 1 screw (2) leaving it held in place by 3 threads.

Press in the screw so that the screw head bottoms out and the slide mounting releases.

Separate the connector for the fog lamp.

Repeat on the other side.

Fig 4: Identifying Bumper Pulled Forwards & Outwards To Release From Bumper Bracket

Courtesy of VOLVO CARS OF NORTH AMERICA.

Pull the bumper forward while pulling both the sides outwards so that the edges release from the slide mounting.

HINT: This operation is easier with two people.