Route cable harness through hole in rear cross member

Fig 1: Pulling Tailgate Sill Trim Panel To Route Cable Harness

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Cut off the rubber bushing on the cable harness
• Lift the bumper into position
• Route the cable harness for the sensors through the existing hole in the rear cross member. Continue to the right in the gap in the rear cross member. Continue out through the hole for the left mounting for the bumper behind the battery
• Remove the left screw (1) in the tailgate sill trim panel
• Pull the panel upwards until it clicks. Then insert the cable harness in the gap between the left floor support and the sill on the tailgate.
  NOTE:

  Ensure that the cable is not trapped.

• Press the sill trim panel back into place. Tighten using the screw.