Activating lamps

Fig 1: Identifying Ignition Switch ON Position

GLL101051

Courtesy of ABLE BODY CORP.

Ignition on
Activate the system test procedures. Check whether the relevant needle or lamp operates correctly.
All needles must move from min to max and back again.

The lamps must flash (not the malfunction indicator lamp (MIL) or turn signal indicator lamps).

The light level in the instrumentation is also checked.

All parts of the instrumentation flash.

Remedy as necessary.

Other information:
- See Driver information module (DIM), replacing
Fig 2: Identifying VCT2000 Diagnostic Tool Symbol In VIDA
Courtesy of ABLE BODY CORP.