Windshield washer fluid reservoir, replacing: Installation

Fig 1: Identifying Windshield Washer Reservoir

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Assemble the hoses for flushing and air. Use an elastic band or tape
• Position the reservoir
• Locate the hoses
• Press the soft nose and the guide out of the way. Then lift the reservoir up into position
• Position the intake air pipe on the mounting on the reservoir
• Lift up the reservoir. Position the intake air pipe on the input on the control module box
• Thread in the screws
• Check the position of the hoses
• Tighten the screws
• Install the remaining components in reverse order.