Throttle body (electronic throttle module (ETM)), replacing: Installation

NOTE:

For tightening torques, see: Tightening torque .

Replacing the electronic throttle module (ETM)

Fig 1: Identifying Electronic Throttle Control Module And Throttle Body

Courtesy of VOLVO CARS OF NORTH AMERICA.

CAUTION:

Ensure that the surfaces between the throttle body (TB) and the intake manifold are clean.

Install a new electronic throttle module (ETM). Use a new gasket. Tighten the 4 screws.

Installing components

Fig 2: Intake Manifold Between Front Cover Plate And Air Cleaner Housing

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the charge air pipe between the electronic throttle module (ETM) and the charge air cooler (CAC).

NOTE:

Heat the pipe at the connections to facilitate installation.

Install the intake pipe between the front cover plate and the air cleaner (ACL) housing.

Finishing

After replacing the electronic throttle module (ETM), the electronic throttle module (ETM) must be adapted using the vehicle communication input: "Adaptation of the electronic throttle unit"

Start the engine and check the function.