Checking wiring and connectors

Check the cable between control module terminal #65 and rear heated oxygen sensor (HO2S) connector terminal #2. Check for an intermittent short-circuit to supply voltage according to Short-circuit to supply voltage, intermittent faults .

Remedy as necessary.

Other information 

• To connect the breakout box and access the control module, see Connecting the breakout box. EMS 2000
• To access or replace the rear heated oxygen sensor (HO2S), see Replacing lambda sond rear
• For information about signals see Signal specification .

Fig 2: Identifying Heated Oxygen Sensor (HO2S) Connector Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 4: Identifying EMS2000

Courtesy of VOLVO CARS OF NORTH AMERICA.

Refer to Information