Checking components and wiring

Check the ABS control module connector. Check for contact resistance and oxidation.

Check the signal cable between ABS control module terminal #14 and combined instrument panel terminal #B16 (#16). Check for a short-circuit to ground. Check for a short-circuit to supply voltage. Check for an open-circuit.

Remedy as necessary.

Other information: 

• See Checking wiring and terminals. Permanent fault
• To connect the breakout box, see Connecting the breakout box
• To access and replace the combined instrument panel, see Driver information module, removing/installing
• For information about signals, see Signal specification .

Fig 1: Identifying Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying ABS Control Module

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Continue 

  Refer to Verification