Checking the cable

Check the cable between the central electronic module (CEM) terminal #1A and the back-up (reversing) lamp switch terminal #2 (3/10). Check for a short-circuit to ground.

Remedy as necessary.

Other information: 

• For information about the central electronic module (CEM), see Central electronic module (CEM), replacing
• To access the back-up (reversing) lamp switch, see Back-up lamp switch, replacing
• See Checking wiring and terminals .

Fig 1: Back-Up Lamp Switch

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ohm Meter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Ground Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Was a fault detected? 

• YES 

  Refer to Verification 

• NO 

  Refer to Replacing the component