Checking the cable
- Ignition off
- Disconnect the connector from the central electronic module (CEM)
- Disconnect connector (9/12) from the front left seat heater.
Check the signal cable between central electronic module (CEM) terminal #11B and front left seat heater (9/12) connector terminal #2. Check for a short-circuit to ground. Check for an open-circuit.
Remedy as necessary.
Other information:
- For information about the central electronic module (CEM) connector, see Central electronic module (CEM), replacing
- To connect the breakout box, see Connecting the breakout box
- -2004: Signal specification
- 2005-: Signal specification
- See Checking wiring and terminals .
Is the cable OK?
- YES
Refer to Verification
- NO
Refer to Replacing the component