Checking the wiring

Unplug the LED connector and check that the LED is intact. Also check the connector for contact resistance and corrosion.

Check the signal lead between the right camera module (RCM) and the #1 LED connector for an open circuit.

Check the ground cable between the right camera module (RCM) and the #3 LED connector for an open circuit.

Remedy as necessary.

Other information 

• -2004: Signal specification
• 2005-: Signal specification
• Change the light emitting diode:
  • Model years -2003, see Door mirror, replacing
  • Model years 2004-, see Door mirror, replacing .
• See Checking wiring and terminals

Fig 3: Identifying Connector Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 4: Identifying Left Camera Module

Courtesy of VOLVO CARS OF NORTH AMERICA.

Refer to Verification